FUTABA T26SZ - Page 175

175
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŏ7DSWKH>3URJPL[HV@EXWWRQLQWKH0RGHOPHQXWRFDOOWKH
setup screen shown below.
ųƕƒƊƕƄƐőŃƐƌƛƈƖ
Program mixing which can be freely customized. Up to 10
mixings can be used for each condition. [All model types]
Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also
EHXVHGIRUXQXVXDOFRQWUROFRQ¿JXUDWLRQV0L[LQJ
means that the motion of a command channel,
called the "master," is added to the motion of the
mixed channel, called "slave."
You may choose to have the Masters trim added to
the Slave channel response, if you desire ("Trim"
setting). The mixing curve can be changed so
that the undesired tendencies can be corrected
H൵HFWLYHO\E\VHWWLQJWKH(;3(;33RLQWPRGHV
2൵VHWW\SHPL[LQJDSSOLHVD¿[HGR൵VHWRUSUHVHW
to the programmed channel servo operation and
may control up to four circuits simultaneously.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with
other programmable mixing functions. The link
function can be set up for Master and Slave channel
individually.
Finetuningtrim
setting
Theontime(start/stoptime)
canbesetupto4seconds.
Itisusefulforlandinggear
controlofthejetorscale
plane,etc.
● Group/singlemodeswitch
(Gr./Sngl)
(Formoreinformation,
seethedescriptionatthe
backofthismanual.)
Mixing/Offsetmode
switch
Afterthisfunctionis
activated,themaster
andslavefunctionnames
(oroffsetmixing)are
displayed.
● Operationcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Activatethefunctionby
tappingthe[INH].
TrimmodesettingON/OFF.
TheON/OFFswitchof
prog.mixesischosen.
Masterfunction
(orStick,Switch,Dial)
ischosen.
Slavefunctionischosen.
Servospeedsetting
ŏ5HWXUQWR0RGHOPHQX