177
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ųƌƗƆƋŃƆƘƕƙƈŃŒŃųƌƗƆƋŃƗƕƌƐ
ųƌƗƆƋŃƆƘƕƙƈ
This function adjusts the pitch operation curve for
each flight condition for the optimal flight state
relative to movement of the throttle stick.
*Up to 17 points can be set for the point curve types.
+RZHYHUZKHQXVLQJWKHSRLQWVRUSRLQWVVSHFL¿HGWR
create a curve, a simple curve can be created by reducing
the number of input points to 3 or 5, and then entering the
VSHFL¿HGYDOXHDWWKHFRUUHVSRQGLQJSRLQWVWKDW\RXFUHDWHG
a curve.
Pointcurvetypeis9
points(initial),butfor
simpleuse,4~5points
aresufficient.
1RUPDOFXUYHDGMXVWPHQW
ŏ)RUQRUPDOFXUYHXVXDOO\XVH>3RLQW@W\SH
and create a basic pitch curve centered
about hovering. Use this function together
with the THR curve (normal) function and
adjust the curve so that up/down control is
best at a constant engine speed.
,GOHXSFXUYHDGMXVWPHQW
ŏ)RUWKHKLJKVLGHSLWFKFXUYHVHWWKH
maximum pitch which does overload the
engine. For the low side pitch curve, create
curves matched to loop, roll, 3D, and
other purposes and use the idle up curves
according to the performance.
7KURWWOHKROGFXUYHDGMXVWPHQW
ŏ7KHWKURWWOHKROGFXUYHLVXVHGZKHQ
executing auto rotation dives.
ŲƓƈƕƄƗƌƒƑŃƓƕƈƆƄƘƗƌƒƑƖ
WARNING
Whenactuallystartingtheengineand
flying,alwayssettheidleupcondition
switchtoOFFandstarttheenginein
theidlingstate.
ŏ6HOHFW>3LWFKFXUYH@DWWKHPRGHOPHQXDQG
call the setup screen shown below.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethedescriptionat
thebackofthismanual.
Currentlyselectedconditionname
ŏ5HWXUQWR0RGHOPHQX