FUTABA T26SZ - Page 178

178
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Normal Curve Idle-up 1 Curve Idle-up 2 Curve Hold Curve
Ɣ3LWFK&XUYH([DPSOH
ŏ*URXS6LQJOHLWHP:KHQ\RXDOVRZDQWWRLQSXW
the same setting contents at other conditions,
perform setting in the group mode. In this case, the
same contents are input to the other conditions
set in the group mode. When you want to set
each condition independently, select the single
mode (initial setting). Other conditions can be set
independently.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
The screens shown below are curves created by
entering the pitch rate at low, center, and high side (3
points or 5 points) at each condition. When actually
creating a curve, input the rate specified at the
fuselage (or the reference value).
*For a description of the curve setting method, see the
description at the back of this manual.
ŦƘƕƙƈŃƖƈƗƗƌƑƊŃƈƛƄƐƓƏƈƖ
Pitchservospeedsetting
(Foradescriptionofthesettingmethod,seethe
descriptionatthebackofthismanual.)