FUTABA T26SZ - Page 180

180
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƋƕƒƗƗƏƈŃƆƘƕƙƈŃŒŃŷƋƕƒƗƗƏƈŃūƒƙƈƕŃƗƕƌƐ
ŷƋƕƒƗƗƏƈŃŃƆƘƕƙƈ
This function adjusts the throttle operation curve
for each condition for optimum engine speed to
throttle stick movement.
Up to 17 curve points can be set for the point
curve type. However, when the 5 points and other
point data is used, a simple curve can be easily
created by reducing the number of input points of
the curve to 5 and entering the specified value at
the corresponding points.
űƒƕƐƄƏŃƆƘƕƙƈŃƄƇƍƘƖƗƐƈƑƗ
ŏ1RUPDOFXUYHFUHDWHVDEDVLFFXUYH
centered around hovering. Use it along
with the normal pitch curve and adjust so
that up/down control at a constant engine
speed is easiest.
ŬƇƏƈŃƘƓŃƆƘƕƙƈŃƄƇƍƘƖƗƐƈƑƗ
ŏ6HWDQLGOHXSFXUYHWKDWPDLQWDLQVD
constant speed at all times, even during
operation which reduces the pitch
SHUIRUPHGLQÁLJKW&UHDWHDFXUYHPDWFKHG
to loop, roll, 3D, or other purposes and the
idle up curve according to the performance.
ŲƓƈƕƄƗƌƒƑŃƓƕƈƆƄƘƗƌƒƑƖ
WARNING
Whenactuallystartingtheengineand
flying,alwayssettheidleupcondition
switchtoOFFandstarttheenginein
theidlingmode.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ*URXSVLQJOHLWHP:KHQ\RXZDQWWR
simultaneously enter the same settings to other
functions, make the settings in the group mode. In
this case, the same setting contents are entered
to the all conditions. When you want to set each
condition independently, make the settings after
selecting the single mode (Initial setting).
ŏ6HOHFW>7KURWWOHFXUYH@DWWKHPRGHOPHQX
and call the setup screen shown below.
Pointcurvetypeis9
points(initial),butfor
simpleuse,4~5points
aresufficient.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethebackofthis
manual.
Currentlyselectedconditionname
Throttlehovertrim
operatingposition
(Whiteline)
ŏ5HWXUQWR0RGHOPHQX