FUTABA T26SZ - Page 181

181
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
Ɣ7KURWWOH&XUYH([DPSOH
The curves shown below are created by using the
point curve type and inputting the data of the 5
points 0% (low side), 25%, 50% (center), 75%,
100% (high) side at each condition. They are
created by reducing the number of points on the
line to 5. When actually creating a curve, enter
WKHGDWDVSHFL¿HGSHUWKHDLUFUDIWRUWKHUHIHUHQFH
value).
*For a description of the curve creation method, see the
description at the back of this manual.
ŦƘƕƙƈŃƖƈƗƗƌƑƊŃƈƛƄƐƓƏƈƖ
ŷƋƕƒƗƗƏƈŃūƒƙƈƕŃƗƕƌƐ
The Throttle Hover trim setup screen can be called from the Throttle curve setup screen.
The Throttle Hover function trims the throttle near
the hovering point. Normally, use it with hovering
conditions. Changes in rotor speed accompanying
changes in the temperature, humidity, and other
ÀLJKWFRQGLWLRQVFDQEHWULPPHG$GMXVWWKHWKURWWOH
so that rotor rotation is most stable. More delicate
trimming is also possible by using this function
along with the Hover Pitch function.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ:KHQXVLQJWKHKRYHULQJQRUPDOFRQGLWLRQRQO\
switch the group mode to the single mode (initial
setting) and make the settings.
ŏ7DS>,1+@21LVGLVSOD\HG
ŏ 6HOHFWWKHDGMXVWPHQWNQRE
Selection example: RD
ŏ7KHWULPRSHUDWLRQPRGH0RGH&HQWHU1RUPDO
can be selected.
Center mode: Maximum rate of change near
center by center trim operation (recommended)
Normal mode: Normal trim (horizontal movement
trim) operation.
ŏ7ULPDGMXVWPHQWUDQJH5DQJHVHWWLQJ
When the value is made small, trim acts only near
the center.
ŏ7KHWULPUDWHFDQEHDGMXVWHGDQGWKHRSHUDWLRQ
direction can be set.
Throttleservospeedsetting
(Foradescriptionofthesettingmethod,seethe
descriptionatthebackofthismanual.)
ŏ5HWXUQWR0RGHOPHQX