FUTABA T26SZ - Page 182

182
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
This function is used to adjust the pitch and
the throttle rise characteristic at acceleration/
deceleration operation. An acceleration function
which temporarily increases the pitch and throttle
operations at throttle stick acceleration/deceleration
operation can be set.
([DPSOHRIDFFHOHUDWLRQIXQFWLRQXVH
ŏ:KHQXVHGDWSLWFKWKHDFFHOHUDWLRQ
function is effective when you want to
quicken the response of the fuselage at 3D
ÁLJKWÁLSHWF
When used, high pitch temporarily exceeds
maximum pitch, but immediately returns to
maximum pitch.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ$FFHOHUDWLRQFDQEHVHWDWERWKVHWWLQJDW
acceleration (high) and setting at deceleration
(low).
(The operation point is displayed on a graph.)
ŏ $FFHOHUDWLRQUDWHVHWWLQJ5DWH
ŏ 7KHUHWXUQWLPHDIWHURSHUDWLRQ'DPSLQJFDQEH
set.
ŏ 7KHRSHUDWLRQSRLQWDWDFFHOHUDWLRQDQG
deceleration can be set. When an operation point
is exceeded, acceleration is performed.
ŤƆƆƈƏƈƕƄƗƌƒƑ
ŏ6HOHFW>$FFHOHUDWLRQ@DWWKHPRGHOPHQX
and call the setup screen shown below.
Operationuptothis
rangewillinitiate
acceleration.
Actposition
Theratetheangle
increases.
Tonextpage
1/2:Pitch
2/2:Throttle
Thereturntimeafteroperation(Damping)can
beset.
（Firstreturn）1 〜 100（Slowreturn）
（Accelerationdoesn'tfunctionas0.）
Whenusingthisfunction,
Tap[INH].(ONis
displayed.)
Conditiongroup/single
modeselection(Gr./
Sngl)
Currentposition
Note: When using the acceleration function,
since the pitch stroke is large, make your
settings so there is no binding of your linkage.
ŏ5HWXUQWR0RGHOPHQX