FUTABA T26SZ - Page 184

184
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŶƚƄƖƋŃƐƌƛƌƑƊ
The swash mix function is used to correct the swash
plate in the aileron (roll) direction and elevator
(cyclic pitch) corresponding to each operation of
each condition.
Adjustment by independent curve for aileron,
elevator, and pitch operations is possible. The
operation can be smoothly adjusted by calling up
the “Curve setup” screen by tapping the mixing
item that corresponds to the mixing and direction
which needs correction.
([DPSOHRIXVH
ŏ$VDQH[DPSOHXVHVZDVKPL[LQJWRFRUUHFW
undesirable tendencies in the roll direction.
ŏ)RUDFRQGLWLRQZKLFKXVHV$LOHURQWR
Elevator, set this function to ON. When
raising the nose at a right roll, when the
Rate B side is input and the right aileron is
operated, the elevator moves to the down
side. Tune by adjusting the Rate. For right
roll, adjust to the rate A side.
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ:KHQXVLQJWKLVIXQFWLRQ7DS>,1+@21LVGLVSOD\HG
ŏ:KHQ\RXZDQWWRVHWWKHVDPHFRQWHQWVDWRWKHU
conditions, select the group mode. When you
want to set the selected condition only, select the
single mode (initial setting).
ŏ7KHFRUUHFWLRQUDWHFDQEHVHWE\FXUYH
ŏ $VZLWFKFDQEHVHW
When [--] is set, the swash mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap to the
[--] item and tap the screen to call the selection
screen and set the switch and its ON position.
ŏ6HOHFW>6ZDVKPL[LQJ@DWWKHPRGHOPHQX
and call the setup screen shown below.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethedescriptionat
thebackofthismanual.
Conditiongroup/single
modeselection(Gr./
Sngl)
ŏ5HWXUQWR0RGHOPHQX