FUTABA T26SZ - Page 186

186
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ųƌƗƆƋ ڀ űƈƈƇƏƈŃ
This mixing is used when the engine is equipped
with needle control or other fuel-air mixture
adjustment. A needle curve can be set.
An acceleration function which temporarily
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
ŏ:KHQXVLQJWKLVIXQFWLRQ7DS>,1+@21LV
displayed.)
ŏ:KHQ\RXZDQWWRVHWWKHVDPHFRQWHQWVDWRWKHU
conditions, select the group mode.
When you want to set the selected condition only,
select the single mode (initial setting).
ŏ $QHHGOHFXUYHFDQEHVHW
ŏ $VZLWFKFDQEHVHW
When [--] is set, the mixing function is operated by
merely selecting the condition.
When setting an [ON]/[OFF] switch, tap to the [--]
item. Tap the screen to call the selection screen
and set the switch and its ON position.
$FFHOHUDWLRQIXQFWLRQVHWWLQJ!
ŏ$FFHOHUDWLRQFDQEHVHWDWERWK
acceleration (high) and deceleration (low).
ŏ7KHDFFHOHUDWLRQUDWHUDWHDQGWKHUHWXUQ
time after operation (damping) can be set.
ŏ$QRSHUDWLRQSRLQW$FWSRVLWLRQDW
acceleration and deceleration can be set.
When an operation point was exceeded,
acceleration operation is performed.
ŏ6HOHFW>3LWFKń1HHGOH@DWWKHPRGHOPHQXDQGFDOOWKH
setup screen shown below.
increases needle operation at throttle stick
acceleration/deceleration operation can be set.
The rise characteristic of the needle servo at
acceleration and deceleration operation can be
adjusted.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethedescriptionat
thebackofthismanual.
Normally,use[Point]type.
ŏ5HWXUQWR0RGHOPHQX