FUTABA T26SZ - Page 27

27
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
2.
Turn on the power switch while pressing the U.MENU
button on the transmitter.
3.
Tap [Receiver setting] on the System menu.
*For safety reasons, receiver settings
cannot be made while radio waves are
being transmitted.
*When using the receiver after setting the
UHFHLYHUWXUQWKHWUDQVPLWWHUSRZHUR൵
and on again.
Andturnon
U.MENU
Keeppressingand…
1
2
4.
Tap [Read]
.
5.
The receiver settings will be displayed. The
displayed contents vary depending on the model.
7.
Tap [Write]. Receiver settings will be changed.
6.
Make the necessary receiver
settings.
9.
Remove the receiver from the transmitter.
8.
Completion message appears, tap [Close]
.
Changingreceiverchanneloutputmode
MODEA → MODEB → MODEC・・・MODEA
DualRXlinkmode
[OFF ⇔ ON]
[INH：TelemetryON]
[ACT：TelemetryOFF]