FUTABA T26SZ - Page 76

76
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Tappingthiswillchange
INHtoeitherOFForON
andactivated.
Tappingthiswillpullupthe
hardwareselectionscreen.Select
theidledownswitchandON-OFF
direction.
Thisisthecurrentpositionbarforthethrottle
stick.Throttlecutwillonlyfunctionwhenthe
throttlestickismorethanhalfwayintothe
lowthrottlerange.
Thisistheidledownthrottle
position.Tappingthiswill
displayvalueinputbuttons
on-screen.Settheengine's
max.lowposition.
Range:
（↑）-100 〜 +100（↓）
Pressingandholdingavalue
willresetitto0.
ŬƇƏƈŃƇƒƚƑ
Lowers the engine idling speed.
The Idle down function lowers the engine's idle
E\ÀLSSLQJDVZLWFKZLWKWKHWKURWWOHVWLFNDWLGOH
The action is not functional at high throttle to avoid
accidental dead sticks. The switch’s location and
direction must be chosen, as it defaults to "
−− "
.
●
Select [Idle down] at the linkage menu and
call the setup screen shown below.
ŬƇƏƈŃƇƒƚƑŃƖƈƗƗƌƑƊŃƓƕƒƆƈƇƘƕƈ
1. Tap the "INH" button to activate the Idle down
function.
2. Idle down function switch setting:
Tap the "--" button to call the <Hardware
select> screen, and then select the switch
and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual.)
●
Return to Linkage menu
3. Offset rate setting:
Tap the offset rate button. Value input
buttons appear on the screen.
Use these buttons to adjust the offset rate.
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHa
*(-)becomes an idle up.
To exit the setting, tap the [Idle down]
button.
Landing
Idling,lower
Offsetrate