FUTABA T32MZ

133
＜
Model Menu (Common Functions)
＞
6HWWLQJPHWKRG
&750PRGH Maximum change near center by center
WULPRSHUDWLRQ'RHVQRWFKDQJHDWHQGRIWKHVWLFN
PRYHPHQW:KHQWKHDGMXVWPHQWUDQJH5DQJHYDOXHLV
made small, trim is active only near the center.
1250PRGH1RUPDOWULPOLQHDURSHUDWLRQ:KHQ
the adjustment range value is decreased, trim is active
only near the center. Needle high trim works as high trim
based on the center. This operation is similar to reverse
ATL trim.
$QDFFHOHUDWLRQIXQFWLRQFDQEHVHW7KLVLVXVHG
ZKHQWKHPL[WXUHLVHLWKHUWRRULFKRUWRROHDQ
ZKLFKFDQEHFDXVHGE\VXGGHQRSHUDWLRQRIWKH
WKURWWOHVWLFN
7KHUHWXUQWLPHDIWHURSHUDWLRQ'XPSFDQEHVHW
IRUERWKVHWWLQJV$FFHOHUDWLRQ+LJK
$QHHGOHWKURWWOHFXWIXQFWLRQFDQEHVHW
7KLVRSHUDWLRQFDQEHOLQNHGZLWKWKHWKURWWOHKROG
IXQFWLRQV&XWDQG,GOH7KURWWOH&XWIXQFWLRQDQG
,GOH'RZQ
7KHQHHGOHVLGHFXWSRVLWLRQFDQEHVHW6HWLWWR
WKHIXHOVLGHIXOORSHQSRVLWLRQ
:KHQMIXPRGHLVVHOHFWHGWKHWKURWWOH
FXUYHVHWWLQJEHFRPHVWKHPDVWHU
,QWKHUNMIXPRGHWKHWKURWWOHVWLFNSRVLWLRQ
EHFRPHVWKHPDVWHU
ŏ5HWXUQWR0RGHO0HQX
ŏ7RXFKWKH>)XHO0L[WXUH@EXWWRQLQWKH0RGHO0HQXWRFDOO
WKHVHWXSVFUHHQVKRZQEHORZ
)XHO0L[WXUH
'HGLFDWHGPL[LQJXVHGLQQHHGOHDGMXVWPHQWRIHQJLQHV
ZKLFKXVHDIXHOPL[WXUHFRQWUROFDUEXUHWRU>$LUSODQH
KHOLFRSWHU@
This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture control
carburetor.
7KHQHHGOHFKDQQHOLVDVVLJQHGWR&+DVDGHIDXOW
ŏ2SHUDWLRQFXUYHVHWWLQJ
)RUDGHVFULSWLRQRIWKHVHWWLQJPHWKRGVHHWKH
GHVFULSWLRQDWWKHEDFNRIWKLVPDQXDO
+(/,&237(5
$,53/$1(*/,'(5