FUTABA T32MZ

175
＜
Model Menu (Helicopter Functions)
＞
+(/,&237(5
*RYHUQRU0L[LQJ
This is used to switch the RPM of the helicopters head.
Up to three rates can be set for each condition.
*The governor is used by connecting the governor speed setting
channel to governor function.
*When using an independent governor [ON]/[OFF] switch, connect
the AUX ([ON]/[OFF]) connector of the governor to Governor2 and
set the switch to Governor2 at the Function menu of the Linkage
Menu.
ŏ5HWXUQWR0RGHO0HQX
ŏ7RXFKWKH>*RYHUQRU@EXWWRQRIWKH0RGHO0HQX
to call the setup screen shown below.
ŏ:KHQWKH´0RGHµEXWWRQ

on
WKH*RYHUQRUVFUHHQLVSUHVVHG
the display mode is switched.
USPPRGH
USPPRGH
ŏ7KHUSPPRGHDQGUSPPRGHDUHGLIIHUHQWZKHQWKH
UDWHLV USPRUJUHDWHU$WUDWHVEHORZWKHUSP
displayis the same for both modes.
ŏ:KHQWKHUSPPRGHLVVHW USP
7KHPD[LPXPYDOXHLV USP
ŏ:KHQWKHUSPPRGHLVVHW USP
7KHPD[LPXPYDOXHLV USP&RQYHQWLRQDO
VSHFLÀFDWLRQV
ŏ7KHUHLVQRFKDQJHLQWKHWUDQVPLWWHURXWSXWHYHQZKHQWKH
USPPRGHDQGUSPPRGHDUHVZLWFKHG&DOLEUDWLRQPXVWEH
SHUIRUPHGDWWKHJRYHUQRUVLGH
Setting method
ŏ7RXFKWKH>,1+@EXWWRQRIWKHUDWHWREHXVHGDQG
GLVSOD\>21@
ŏ:KHQ\RXZDQWWRVHWWKHVDPHVHWWLQJVWRRWKHU
FRQGLWLRQVVHOHFWWKHJURXSPRGH*U:KHQ\RXZDQW
WRDGGVHWWLQJVWRWKHVHOHFWHGFRQGLWLRQRQO\VHOHFWWKH
VLQJOHPRGH6QJO
ŏ7KUHHVSHHGVUDWHVFDQEHVHWIRUHDFKFRQGLWLRQ
5DWH5DWH5DWH
ŏ(QGSRLQWLQLWLDOL]DWLRQ
7KHJRYHUQRURXWSXWFKDQQHOHQGSRLQW$79´WUDYHOµ
DQG´OLPLWµDUHQRZLQLWLDOL]HGZKHQWKHJRYHUQRUVHWWLQJ
´2SHUDWHµEXWWRQZDVSUHVVHG
ŏ:KHQVZLWFKHGIURP,1+WR21RU2))´WUDYHOµLV
LQLWLDOL]HGWRDQG´OLPLWµLVLQLWLDOL]HGWR
ŏ:KHQ´2SHUDWHµRIUDWHVDQGLVVZLWFKHG
WR,1+XQGHUDOOFRQGLWLRQV´WUDYHOµLVLQLWLDOL]HGWR
DQG´OLPLWµLVLQLWLDOL]HGWR
*When using the Fuel Mixture function, the mixture servo is
controlled from the governor. When transmitting the mixture curve
data from the transmitter to the governor, the governor AUX (m.trm)
connector must be connected to Governor2 function and governor
VLGHVHWWLQJSHUIRUPHG6HHWKHJRYHUQRULQVWUXFWLRQPDQXDO
Note: Always set (Act) and (Trim) to [NULL] for [Governor]
and [Governor 2] of the Function menu.
The subtrim of [Governor] is made 0%.
Make the reverse direction normal.
 $OVRWKLVPL[LQJDQGWKHJRYHUQRUVLGHVSHHGVHWWLQJ
PXVWEHPDWFKHGEHIRUHKDQGE\WKHIROORZLQJPHWKRG
ŏ6HWVRWKDWZKHQWKHJRYHUQRUVLGHLVSODFHGLQWKH
VSHHGVHWWLQJLWHPVWDWHDQG>USP@RI6HW*29RI
WKHVFUHHQDERYHLVWRXFKHGWKHJRYHUQRUVSHHGLVVHW
WRZKHQWKH>USP@EXWWRQLVWRXFKHGWKH
JRYHUQRUVSHHGLVVHWWRDQGZKHQWKH>USP@
EXWWRQLVWRXFKHGWKHJRYHUQRUVSHHGLVVHWWR
ŏ:KHQ\RXZDQWWRUHDGWKHVSHHGGLUHFWO\SUHVVWKH>@
EXWWRQDQGGLVSOD\>USP@
ŏ7KHVSHHGFDQEHZLWFKHGE\VHWWLQJDVZLWFK$OVR
ZKHQ>2))@LVVHWLQVWHDGRIVSHHGVHWWLQJWKHJRYHUQRU
FDQEHWXUQHG>21@>2))@ZLWKRXWVHWWLQJDVHSDUDWH
>21@>2))@VZLWFK
ŏ$VSHHGÀQHWXQLQJ95FDQEHVHW
95VHOHFWLRQDGMXVWPHQWZLGWKDQGDGMXVWPHQW
direction can be set.