FUTABA T32MZ

19
＜
Before Use
＞
Stick Adjustment
Adjustment of the stick lever angle
<RXFDQPDNH¿QHDGMXVWPHQWVWRWKHDQJOHRIDVWLFNOHYHU
either inwards or outwards from the center stick position.
Use the attached 1.5 mm hexagonal wrench (inside
VW\OXVWRWXUQWKHVFUHZFORFNZLVHWRDGMXVWWKHVWLFN
outwards, or counter-clockwise to tilt it inward.
Note:
Be careful not to turn the screw too far counterclockwise
as it could fall out.
Adjustment of the lever length
<RXFDQDGMXVWWKHOHQJWKRIVWLFNOHYHUVLI\RX
OLNH,WLVUHFRPPHQGHGWRDGMXVWWKHOHQJWKRIWKH
sticks in line with your hand size.
/HYHUKHDG$
/HYHUKHDG%
6FUHZ
>+RZWRDGMXVWWKH6WLFNOHQJWK@
1. Hold the lever head "B" and turn the lever head "A"
counter-clockwise, the lock will be released.
2. Adjust the stick lever to the desired length by
turning lever head A.
3. Securely lock the stick lever by holding lever head
A and turning lever head B counterclockwise.