FUTABA T32MZ

29
＜
Before Use
＞
Output
connector
Channel
Mode A
1
〜
8CH
Mode B
1
〜
7CH
Mode C
9
〜
16CH
Mode D
9
〜
15CH
11199
2221010
3331111
4441212
5551313
6661414
7/B 7 7 15 15
8/SB 8 S.BUS 16 S.BUS
Red LED
blink
1 time 2 times 3 times 4 times
R7108SBCHModetable
Default
ChannelModes
The R7108SB is capable of changing its channel allocations as
described in the table below. This is especially important when
using the receiver in a dual receiver mode.
1
Turn on the receiver. [Transmitter is always OFF]
2
Press and hold the Link/Mode button for 5 seconds to 10
seconds.
3

When the LED of the receiver changes from blinking red
to blinking red with green, Link/Mode button is released.
4
The LED should now blink red two times in the patterns
described in the chart below.
5

Each press of the Link/Mode button advances the
receiver to the next mode.
6

When you reach the mode that you wish to operate in,
press and hold the Link/Mode button for more than 2
seconds.

When LED blinks in green with red, it is the
completion of a mode change, Link/Mode button is
released.
7

Please cycle the receiver power off and back on again
after changing the Channel mode.
5HFHLYHU
Do not insert either a switch
or battery in this manner.
DANGER
LEDIndication
System Status LED
FASSTest
Nosignalreception RedSolid
Receivingsignals GreenSolid
Waitingforlink
Start → 2second
later → Red
Blink（1second）
FASST
Nosignalreception RedSolid
Receivingsignals GreenSolid
Receivingsignals
butIDisunmatched
GreenBlink
Waitingforlink RedBlink
FASSTest
FASST
Unrecoverableerror
(EEPROM,etc.)
Alternateblink
GreenLED
blink
System
1time FASSTest
2times FASSTMulti-chNormalmode
3times FASSTMulti-chHigh-speedmode
4times FASST7chNormalmode
5times FASST7chHigh-speedmode
R7108SBSystemtable
*FASST mode cannot use telemetry functions.
Systems(FASSTest ⇔ FASST)changemethod
1
Turn on the receiver. [Transmitter is always OFF]
2
Press and hold the Link/Mode button for 10 seconds to 15 seconds.
3
When the LED begins to blink green the button may be released.
4
The LED should now be blinking green in one of the patterns
described by the chart below.

(Default : FASSTest )
5
Each press of the Link/Mode button advances the receiver to the
next system.
6
When you reach the system that you wish to operate in, press and
hold the Link/Mode button for more than 2 seconds.

When the LED
blinks green and red, the system change is complete. Release the
Link/Mode button.
7
Please cycle the receiver power off and back on again after
changing the system.
Default