FUTABA T32MZ

88
＜
Linkage Menu
＞
+(/,&237(5
$,53/$1(
*/,'(5
ŏ5HWXUQWR/LQNDJH0HQX
ŏ7RXFKWKH>6XE7ULP@EXWWRQLQWKH/LQNDJH0HQXWRFDOOWKH
VHWXSVFUHHQVKRZQEHORZ
6XE7ULP
6HWWLQJRIQHXWUDOSRVLWLRQRIHDFKVHUYR
7KHGLVSOD\VFUHHQLVDQH[DPSOH7KHVFUHHQGHSHQGVRQWKHPRGHOW\SH
The Sub-Trim function is used to set the servo neutral
position, and may be used to make fine adjustments
to the control surface after linkages and pushrods are
hooked up. When you begin to set up a model, be sure
that the digital trims are set to their center position.
6XEWULPDGMXVWPHQW
7RXFKWKHWULPGLVSOD\SDUWRIWKHFKDQQHO\RX
ZDQWWRDGMXVW
$GMXVWPHQWEXWWRQVDSSHDUVRQWKH6XE7ULP
PHQXVFUHHQ
8VHWKHDGMXVWPHQWEXWWRQVWRDGMXVWWKHVXEWULP
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
6HHDERYH
5HSHDWWKLVVWHSIRUHDFKFKDQQHO