FUTABA T8J-2.4G - Receiver Modulation Selection (RX); Setting Receiver Modulation Type

31
Receiver modulation select (
RX
): sets the type of modulation transmitted.
The modulation of your receiver will determine whether you utilize
SFHSS
or
FHSS
setting in
RX
during transmission.
1RWHWKDW\RXKDYHWRWXUQ\RXUWUDQVPLWWHURIIDQGEDFNRQEHIRUHDPRGXODWLRQFKDQJHEHFRPHVHIIHFWLYH%HVXUH\RX
XQGHUVWDQGDQGVHWWKH)DLO6DIH
F/S
) settings as you intended (see p. 48).
SFHSS
/
FHSS
)+66*+]V\VWHP
SFHSS
mode/
FHSS
mode)
Adjustability:

SFHSS
VHWWLQJIRUDOO)XWDED6)+66*PRGHUHFHLYHUVUHJDUGOHVVRI
number of channels.

FHSS
VHWWLQJIRU DOO )XWDED)+66*PRGHUHFHLYHUVUHJDUGOHVVRIQXPEHU
of channels.
NOTE: When you change models in
MODEL SELECT
, if the new model is set to the other modulation type,
\RXPXVWF\FOHWKHWUDQVPLWWHUSRZHUWRFKDQJHPRGXODWLRQV7KHPRGXODWLRQZLOOÀDVKRQWKHKRPHVFUHHQ
to remind you until you do so. See p. 27,
MODEL SELECT
, for details.
GOAL of EXAMPLE: STEPS: INPUTS:
Change model 1 from
SFHSS
to
FHSS
. Confirm you are currently using the
proper model memory (Ex: 1)
2QKRPHVFUHHQFKHFNPRGHOQDPHDQG
number on top left and the modulation
on top right. If it is not the correct
model, use
MODEL SELECT
, p. 27.
Open the menu, then open
PARAMETER
submenu.
for 1 second.
to
PARAMETER
.
Go to
RX
and change setting.
to
RX
. to
FHSS
.
cycle power ÀDVKHVRQVFUHHQ
Cycle power. Cycle power.
Where next? Now that the model is in the proper modulation, the T8J should communicate
ZLWKWKHUHFHLYHU,ILWGRHVQRWFRQ¿UPWKHW\SHRIWKHUHFHLYHU
Change
MODEL TYPE
to airplane/helicopter: see p. 30.
Set
F/S
settings for when
2.4G
receiver sees interference: see p. 48.
Utilize servo
REVERSE
: see p. 35.
Adjust servo travel with
END POINT
: see p. 36.
Set up dual/triple rates and exponential (
D/R
,
EXP
): see p. 39.