FUTABA T8J-2.4G - AIRBRAKE Setup Example; Example: Activating AIRBRAKE with FLAPERON

61
GOAL of EXAMPLE: STEPS: INPUTS:
Activate
AIRBRAKE
on a
FLAPERON
.
model. Adjust the flaperon travel to
75%
,with negative elevator (push) of
25%
.
&RQ¿UP
FLAPERON
is active. see
FLAPERON
instructions.
Open the
AIRBRAKE
function.
for 1 second.
to
AIRBRAKE
.
Activate the function.
Switch C in up position.
to
MIX
. to
OFF
.
SW selection.
A position is turned ON by down with a
center.
to
SW
. to
SWC
.
to
DOWN
. to
CT&DN
.
Adjust the travels as needed.
(Ex:Ailerons each
75%
, Elevator
-25%
.)
to
AIL1
. to
75%
.
to
ELEV
. to
-25%
.
to
FLAP
. to
75%
.
2SWLRQDOGHOD\KRZTXLFNO\WKH
elevator servo responds.
WRGHOD\
ELEV
. to
25%
.
Optional: change the mixing from full
amount upon switch to proportional to
the THROTTLE STICKV SUR[LPLW\ WR
idle.
to
MODE
. to
LINR
(
0%
).
to
0%
.
THROTTLE STICK to desired
point.
for 1 sec, until beeps
(display changes if new setting is different from prior
setting).
Close menu.
Where next? $GMXVWÀDSHURQVWRWDOÀDSWUDYHODYDLODEOH
FLAPERON
): see p. 50.
Set up
ELE-FLAP
mixing: see p. 59.
9LHZDGGLWLRQDOPRGHOVHWXSVRQWKHLQWHUQHWZZZIXWDEDUFFRP?IDT?