EasyManuals Logo

FUTABA TM-FH User Manual

FUTABA TM-FH
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
position alarm mentioned above, the T6J will sound an audible warning and display a
visual warning on the screen also.
These warning signals will continue until the switch(es) are returned to their off
positions.
BATTERY CHARGING PROCEDURES AND PRECAUTIONS
          
NiCd/NiMH battery pack, both available separately. The transmitter batteries used are a matter of personal
preference.
AA Alkaline batteries are available at any local hobby shop, grocery store, etc. A NiCd/NiMH battery pack
will need to be purchased from a hobby shop.
Charging NiCd/NiMH batteries
As noted above, the T6J transmitter will function with four dry cell batteries, however, some modelers will
opt to purchase a NiCd/NiMH battery pack and charger for use with this transmitter.
Failure to exercise caution while using this product and to comply with warnings pertaining to the charging

Whether you choose NiCd (nickel cadmium, pronounced nI-kad) or NiMH (nickel metal hydride) batteries,
these packs require special care and charging. Read the charging instructions carefully.
NOTE: The batteries are generally supplied partially charged but will require a full, overnight charge before

1) With the transmitter power off, connect the transmitter charging cord coming from the A/C wall charger
to the charge jack in the right side of the transmitter case. The receiver charging cord may be connected to
the batteries two different ways: The charge cord may be connected directly to the battery pack, or to the
vacant charge connector (black) coming from the on/off switch in the model. Charging through the switch
is preferred as there will be no need to disconnect the battery.
2) Plug the A/C wall charger into a wall outlet. Note: If the wall outlet can be turned off by a switch in the

       
are being charged. Discharged batteries will take about 15 hours to fully charge. If using an aftermarket
 
not overcharge the batteries. NEVER charge the batteries at a rate higher than recommended by the
manufacturer. Depending upon the battery cell construction, the batteries should also be discharged

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA TM-FH and is the answer not in the manual?

FUTABA TM-FH Specifications

General IconGeneral
BrandFUTABA
ModelTM-FH
CategoryRemote Control
LanguageEnglish

Related product manuals