Original User Manual FUXTEC FX-PS152 / FX-PS162
18
9. Cold start of the engine
1. Place the device on a firm and flat surface.
Slide the engine stop switch forward to position 1.
2. Move the choke lever upwards to "COLD START."
3. Press the carburetor pump about 8-10 times (until gasoline flows in the line)
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, mainly fast train will provide a strong spark, and the engine
will respond after 2-3 trains.
5. Necessary: Set the choke lever to the "WARM START" position after the engine has
responded and immediately pull the starter again until the engine starts. '' see also video
device start on our homepage.''
6. Let the engine warm-up at idle for about 10 minutes
To Next Page
Loading...
Need help?
General
