Original User Manual FUXTEC FX-PS152 / FX-PS162
9
● Children must not have access to the device. Spectators should stand at a safe
distance of at least 15 meters from the working area.
● Keep hands and feet away from the nylon cutting head or metal blade during
operation.
● Do not use the device if you are tired, ill, or under the influence of medicines, drugs,
or alcohol.
● Use an undamaged nylon cutting head. If you hit a stone or any other obstacle, stop
the device and check the nylon cutting head. A defective or unbalanced nylon
cutting head must never be used.
● Before starting, after failure or impact, always check the device and make sure that
it is in good condition.
● Attention! Local regulations may limit the use of the device
● Always keep the device with the cutting tool in good condition. Observe, improper
maintenance, the use of non-compliant spare parts or removal, or modification of
the safety devices can cause damage to the device and severe injury to the person
working with it.
● Secure the device properly during transport to prevent loss of fuel, damage to the
device, and injury. Always fit the transport protection of the cutting blade before
transporting or stowing the device.
● For devices with a clutch, regularly check that the cutting attachment stops rotating
when the engine is idling.
● Check the device for loose fasteners, fuel leaks, damaged parts, etc. before each
use. Replace damaged parts before use.
● It is necessary to take sufficient breaks and change the working position.
● Do not store the device in an enclosed area where fuel vapors can reach an open fire
from water heaters, stoves, etc. Store the device in a well-ventilated area only
● IMPORTANT: When filling the fuel, make sure that the device is off and cooled
down. Never refuel when the device is running or hot. If gasoline is spilled, wipe it
up before starting the device
To Next Page
Loading...
Need help?
General
