Original User Manual FUXTEC FX-RM Series_rev15
18
IMPORTANT: on some models, the front wheels are removed to prevent damage to the axle during shipping. The wheels are
simply screwed onto the axle with the nuts supplied.
ADJUSTING THE CUTTING HEIGHT
Raise the wheels for low cutting height and lower the wheels for high cutting height. Adjust the cutting height according to your
needs centrally using the height adjustment handle (see illustration on page 2). The middle position is the most suitable
position for most lawns.
FILL OIL BEFORE STARTING THE ENGINE
Before each subsequent use, check the oil level and, if necessary, top up with SAE30 engine oil. Refer to the table in Chapter 1
Product Specification for the filling quantity.
Your lawnmower is delivered to you without 4-stroke oil.
ATTENTION: DO NOT overfill the engine with oil. It could
lead to the smoke formation in the muffler when starting.
1. Make sure that the lawnmower is level
2. Remove the dipstick from the oil filler tube
3. Insert the dipstick and pull it out slowly to check the oil level
IMPORTANT:
- Check the oil level before each use. Add oil if necessary. Fill up to the oil gauge on the dipstick.
- Change the oil every 25 working hours or every season. You will likely need to change the oil more often in dusty and dirty
conditions. Refer to chapter 10 "Changing the oil."
Refuel with SUPER GASOLINE 95 octane (no mixture)
Fill the fuel tank to the bottom of the filler neck. Do not overfill the tank. Use fresh, clean unleaded fuel. Never mix oil with
gasoline. Purchase fuel in quantities that can be used within 30 days to guarantee the freshness of the fuel.
Prolonged storage of the lawnmower will change the chemical composition of the gasoline, which can cause starting difficulties
and unsteady running of the engine.
ATTENTION: Remove any oil or gasoline residue. Do not store, spill, or use gasoline near naked flames.
To Next Page
Loading...
Need help?
General
