What to do if my FUXTEC FX-RB144 Lawn Mower stops working and beeps?
If your FUXTEC Lawn Mower stops working and beeps, it could be due to several reasons: * The mower might be lifted from the ground. In this case, place the mower on level ground and restart it. * Someone or an object might be on the mower. Remove any obstructions and restart the mower.
Why does my FUXTEC FX-RB144 Lawn Mower keep stopping and beeping?
If your FUXTEC Lawn Mower stops working and beeps, it could be due to these issues: * The running wheel might have struck hard objects. Ensure the lawn is clear of any hard objects. * The mower might be trapped in the lawn. Clear the area or restart the mower in a different location.
What to do if FUXTEC FX-RB144 stops, beeps, and won't move?
If your FUXTEC Lawn Mower stops working and beeps, consider the following: * The cutting height might be too low. Adjust it to a more suitable level. * The blade might be hitting hard objects. Clear the lawn of any obstacles. * The mower might be stuck. Clear the area or restart the mower.
Why is my FUXTEC FX-RB144 so noisy?
If the FUXTEC Lawn Mower is very noisy, it may be due to the following reasons: * The cutting blade is damaged. Replace it with a new one. * Residues are flooding the cutting blade (tapes, ropes, plastic fragments, etc.). Stop the mower safely, use protection gloves to avoid the risk of cuts on hands, remove the fold cause from blade. * The mower started too close to obstacles (less than 1m away) or unexpected obstacles are present (fallen branches, forgotten objects, etc.). Start the robot in a new place. * The running motor or cutting motor is damaged. Get the motor repaired or replaced by a service station. * The grass is too high. Increase the cutting height or use a normal lawn mower.
What does it mean when my FUXTEC Lawn Mower stops and beeps?
If your FUXTEC Lawn Mower stops working and beeps, it might be because the mower is tilted more than 30 degrees from the ground. Turn off the mower, move it to level ground, and then restart it.
Why won't my FUXTEC FX-RB144 start in AUTO mode and the charging station beeps?
If your FUXTEC Lawn Mower isn't starting even after entering the correct password and selecting AUTO mode, and the charging station is beeping, it could be due to: * The virtual wire failing to send signals. Check the virtual wire light on the charging station to ensure the virtual wire is connected properly (light should be colorless). * The virtual wire being cut off. Connect the virtual wire using wire connectors.
Why does my FUXTEC FX-RB144 stop and beep when touched?
If your FUXTEC Lawn Mower stops working and beeps, it could be because the handle was touched, activating the inside touch sensor. Turn off the mower and restart it. If needed, the touch sensor can be disabled in the menu.
Why FUXTEC FX-RB144 Lawn Mower won't start after password and selecting AUTO mode?
If your FUXTEC Lawn Mower isn't starting in AUTO mode after you input the correct password, it could be due to: * The main power being off. Check the power and ensure the charger is properly connected to both the power supply and the charging station. * Poor communication between the charging station and the mower. Verify the power connections to the charger and charging station.
What to do if FUXTEC FX-RB144 stops beeping and won't start in AUTO or HOME?
If your FUXTEC Lawn Mower stops and beeps, and you can't start AUTO or HOME mode, it might be due to: * The mower losing contact with the charging station. Ensure the charging station is powered on and the virtual wire is connected. * Address mismatch between mower and station. Match the address between mower and station, refer to 5.6Address setting.
Why are my FUXTEC Lawn Mower batteries not recharging?
If your FUXTEC Lawn Mower batteries aren't recharging, it could be: * The charger isn't powered on. Check if the charger is properly connected. * The battery life is decreasing. Send the mower to a service station to replace the battery.
General| Cutting Width | 46 cm |
|---|---|
| Mulching Function | Yes |
| Power Source | Petrol |
| Engine Displacement | 144 cc |
| Drive | Self-propelled |
| Cutting Height Adjustment Type | Central |
To Next Page
