FUXTEC FX-RB144 - Sensor and System Errors

- 19 -
7 . TROUBLE SHOOT I NG
Problem
Display
Possible reasons
Solutions
Mower stops working
and beeps.
1.Mower is tilted over
than 30 degrees from
the ground.
Turn off the mower and take
the mower to level ground.
Then restart the mower.
Mower stops
working and beeps.
1.Handle is touched and
the inside touch sensor
is activated
1.Turn off the mower and
restart it.
And the touch sensor
could be turned off in
menu if needed.
The batteries can not
recharge
1. Charger is not powered
on.
2. Battery lifetime
decreases.
1. Check whether charger
is well connected.
2. Send the mower to
service station and replace
the battery.
1. Grass is extremely
1. Cut the grass
appropriate height.
2. Fill in all holes, cover or
exclude all exposed roots
in order to smooth the
terrain.
overgrown or very wet,
2. Terrain needs
landscaping repairs.
Mower does not
complete the edge.
Obstacle along the path.
Watch the full operation of
follow virtual wire walking
and confirm no obstacle
is present.
Mower does not detect
the charging station
contacts.
The ground before the
charging station isn’t flat.
Reset the charging station
in a flat place.
Mower reaches
charging station, its
contacts are above the
charging sheets.
Height difference between
the charging station and
lawn surface at the
entrance to charging station.
Confirm the ground before
the charging station is leveled
with the station if necessary
fill areawithdirtandleveloff.
The mower behaves in
an anomalous around
flower beds.
Virtual wire incorrectly
placed
Relocate the virtual wire.