3.4
Virtual wire installation
The virtual wire can be installed in one of the
following ways:
-
Securing the wire to the ground with pegs.
It is preferable to staple down the virtual wire, if you
want to make adjustments to the virtual wire during
the first few weeks of operation.
-
Bury the wire
It is preferable to bury the virtual wire(max depth: 5cm)
if you want to detach or aerate the lawn.
If necessary both methods can be combined so one
part of the virtual wire is stapled down and the
remainder is buried.
-
Install virtual wire with pegs 1 meter apart.
It’s best to use smooth radius corners than
sharp angles. See pictures.
-
Bury virtual wire below grass and fasten it on
the ground with pegs, so that the mower should
not cut the wire.
Add pegs in order to pull the
virtual wire
virtual wire down to the ground
surface, below the grass tips.
-
A minimum distances between the front of the charging
station and an obstacle is 2 meters. And make sure the
distance from corner to front of charging station is at least
2.5 meters. Make sure to lay a 2.5 meters minimum
straight-light of virtual wire in front of charging station.
-
If a high obstacle, for example a house, wall, fence or
other obstacle which is higher than the cutting lawn
borders the working area, the virtual wire should be laid
at least 40cm from the obstacle. This will prevent mower
from colliding with the obstacle.
-
If a passage or a ground with same height of cutting lawn,
the virtual wire should be laid at least 10cm from the edge.
-
A minimum distance between the pool edge of virtual
wire is 40cm.
-
A minimum distance between two corners is 1meter.
>90
Min:40cm
10cm
- A maximum distance of the virtual wire
Passage or
a ground with
same level
of the lawn.
House
,
wall, fence or
other obstacle higher
than the lawn
40cm
Min40cm
Pool
Max:1cm
Straight-line
at
to and from the island is 1cm, and fix the
two wires with one peg.
- There are two types of set up of the
virtual wire around the charging station.
Put the charging station near corner.
please take location for reference.
Please make sure to set a straight-line
at least of 2.5m in front of charging
station. The charging station should be
far away from puddle.
Location
IMPORTANT
INFORMATION
Hard
or
dry
ground
may
cause
pegs
to
break
when
driving
them
in.
In
extreme
cases,
watering
the
lawn
where
the
pegs
will
be
driven.
To Next Page
Loading...
Need help?
General
