3. INSTALLATION
This chapter describes how you to install this mower.
Before starting the installation, read the previous
chapter 2. Presentation.
Read the whole of this chapter before starting the
installation. How the installation is made also affects
how well the mower will work. It is therefore important
to plan the installation carefully.
3.1
Preparations
Training
-
Read the instructions carefully. Be familiar with the
controls and the proper use of the mower.
-
Never allow people unfamiliar with these instructions
or children to use the mower. Local regulations
may restrict the age of the operator.
-
The operator or user is responsible for accidents or
hazards occurring to other people or their property.
3.2
Hardware
adjustments Blade
adjustment
The mowing system used by this mower is based on
an effective and energy efficient principle. Unlike
normal lawn mowers, the mower cuts the grass instead
of striking it off.
Rain sensors on the mower is optional(See P15-5.8 RAIN),
we recommend you allowing the mower to mainly mow in
dry weather to obtain the best possible result. Even
though the mower can mow in rain, wet grass easily
collects on the mower and the risk of slipping on steep
slopes is greater.
The blades must be in good condition to obtain the best
mowing result. In order to keep the blade sharp for as
long as possible it is important to keep the lawn free
from branches, small stones and other objects
(especially the objects less than 6cm height). Please fill
up small holes and even out small mounds to make sure
lawn is flat.
How to adjust the cutting height:
1.
Select SET and enter it by pressing key .
2.
Select CUTTING HEIGHT and enter it by pressing key .
3.
Select cutting height from 2.5-5.5 by pressing key .
4.
confirm it by pressing .
Cutting height explanation: take 3cm level for example.
3.3
Charging station installation
-
Choose best installation place, please make sure
it is flat, no water, no magnetic interference and no
obstacle in the front of charging station.
Charging station best install place:
1. Make sure it is flat
2. No magnetic interference
3. No water and far away from puddle
4. No obstacle in front of charging station
-
Please fix the charging station on horizontal place and
correct direction.
-
Lay virtual wire
as picture shows.
- Fix the charging
station with four
stakes by
hammer.
IMPORTANT
INFORMATION
Before
fix
the
charging
station
on
the
lawn,
please
note
mower
must
follow
the
virtual
wire
and
back
to
station
in
CLOCKWISE
direction.
IMPORTANT
INFORMATION
Do
not
tread
or
walk
on
the
charging
station
plate.
To Next Page
Loading...
Need help?
General
