Original Bedienungsanleitung FUXTEC FX-RT226_rev02
36
replace the guard or cutting tool, make sure that the machine and cutting tools
have come to a standstill
● The machine must be OFF before changing the operating range of the machine
● If necessary, have the machine repaired by an authorized dealer. If the machine
is defective, do not continue to operate it
● When starting or operating the machine, never touch hot parts such as the
exhaust, the ignition cables, or the spark plug
● After the engine is stopped, the exhaust is still hot. Never place the machine
near fire-resistant materials (dry grass, combustible gases or flammable liquids,
etc.)
● Make sure that the ground can be smooth during operation in the rain or
immediately after the rain
● If you fall or fall to the ground, release the throttle lever immediately
● Before removing the lock, stop the machine and remove the spark plug
connector. Before the machine is to be adjusted or repaired, be sure the machine
is stopped and the spark plug plug is peeled off.
● Be careful not to drop or hit the machine against obstacles
● If the machine is to be stored for an extended period, drain fuel from the fuel
tank and the carburetor, clean the parts, place the machine in a safe place, and
ensure that the machine has cooled down completely
● Perform continuous checks for safe and efficient operation of the machine. For a
complete inspection, please contact a Fachwerkstatt
● Keep the machine away from fire or from sparks
● Be careful when using. There are risks of kickback and backlash
● Be extremely careful when using this machine with the cutting knife. A cutter
backlash is a reaction that can occur when the rotary cutter hits an object that
can not be cut. This contact causes the cutting knife to stop for a moment and
then suddenly to push off the hit object with accelerated force. This kickback
reaction can be severe enough that the operator loses control of the machine. A
knife backlash can be done without warning when the cutter hits an obstacle, is
blocked or stuck. This is more likely in areas where it is difficult to survey the
material that is to be cut. For easy and safe cutting, go from the right to the left
side of the weed to be cut. In the event that an object or wooden stick is
unexpectedly hit, this can reduce a knife blade backlash
To Next Page
Loading...
Need help?
General
