EasyManuals Logo

FUXTEC FX-RT226 User Manual

FUXTEC FX-RT226
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Original Bedienungsanleitung FUXTEC FX-RT226_rev02
50
32. Trouble shooting
Situation Reason Solution
No spark
spark plug
Kohleablagerung zwischen den
Dioden der Zündkerze
Clean the spark plug.
Adjust distance from
0.6 to 0.7mm
change the spark plug
others
Ignition coil defect Change the ignition
coil
Weak spark
compression
Too much fuel in the combustion
chamber, poor fuel or water in the
tank
Remove spark plug
and let it dry, replace
fuel.
Carburettor does not
pump oil.
Oil pipe blocked
Clean the carburetor
and the fuel lines
Normal oil intake,
but weak
compression
Piston rings worn, spark plug not
tightened, cylinder head not tight
wrong valve clearance or ignition
time.
Replace or adjust
Normal oil supply
and good spark
Bad contact between ignition cap
and spark plug
Replace or adjust
2. problems during operation
Situation Reason solution
Engine does not
reach speed
Choke is in "COLD START" position,
exhaust system no air supply, moving
elements worn out, sparkle weakly too
large valve play, cylinder head soothed
Open choke, change exhaust gas
system Check or replace ignition coil,
adjust flywheel, spark plug
Operating fluids
are running out
Fuel lines to carburetor clogged
Spark plug gap is incorrect
Replace fuel lines and adjust gap of
carburetor
Engine sounds
Choke wrong position,
Crankshaft damaged
Change engine or crankshaft
carburetor leaky
Failure of check valve on tank cap change tank cap
Carburetor gasket worn out
Replace
carburetor or gasket

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUXTEC FX-RT226 and is the answer not in the manual?

FUXTEC FX-RT226 Specifications

General IconGeneral
BrandFUXTEC
ModelFX-RT226
CategoryBrush Cutter
LanguageEnglish

Related product manuals