Original Bedienungsanleitung FUXTEC FX-RT226_rev02
47
31. Replace nylon head
1. Turn off the engine
2. Place the trimmer on the ground so that the drive axle is free with the reel and
dismantle the nylon head
3. Open the nylon head by pressing the release button
4. Cut the new thread on 4m and wrap it clockwise around the thread pick-up
5. Remove the unnecessary thread
6. After the thread receiver is wrapped, attach the thread ends as shown in the figure
7.Remove the thread ends through the holes in the outer coil part
8. Press the inner coil together with the outer coil and turn it against each other until
you click into place
INFO
: we offer (with a suitable 8mm right-hand thread for FX-RT models) which can be
filled without opening the head of the thread. Look on the webshop EASY-FIT nylon head
To Next Page
Loading...
Need help?
General
