Original Bedienungsanleitung FUXTEC FX-RT226_rev02
44
28. Start warm engine
1. Place the machine on a firm and flat surface.
2. Slide the motor stop switch down
3. Slide the choke to the "WARM START" position,
4. Pull out the starter cable with a short stroke until resistance is felt
(About 100mm). A continuous, especially fast train will provide a strong spark and start
the engine
If machine does not start, please proceed according to "cold start of the machine"
29. Stop engine
Return machine to idle. Slide the engine stop switch on the handle upwards until the
machine stops. If this does not stop, pull the spark plug connector in an emergency.
Never leave the machine unattended while the machine is running.
30. CUTTING WITH A NYLON HEAD
WARNING DANGER The proper debris shield must be in place on the unit when
nylon cutting line is used. The cutting line can flap around if too much line is
exposed. Always use the plastic debris shield with cut-off knife when using
nylon cutting heads.
For nearly all cutting, it is good to tilt the line head so that contact is made on
the part of the line circle where the line is moving AWAY from you and the
debris shield. (See appropriate picture) This results in the debris being thrown
AWAY from you.
WARNING DANGER Tilting the head to the wrong side will shoot the debris
TOWARDS you. If the line head is held flat to the ground so that cutting occurs
on the whole line circle, debris will be THROWN at you, drag will slow the
engine down, and you will use up a lot of line.
Use only quality nylon monofilament line of the diameter 2.5mm. Never use
wire or wire-reinforced line in place of nylon trimmer line. Load your nylon line
cutting head only with nylon trimmer line of the proper diameter.
To Next Page
Loading...
Need help?
General
