Original Bedienungsanleitung FUXTEC FX-RT226_rev02
45
Use extreme caution when operating over bare spots and gravel, because the
line can throw small rock particles at high speeds. Debris shields on the unit
cannot stop objects which bounce or ricochet off hard surfaces.
Line head rotates in a CLOCKWISE direction.
The CUTOFF KNIFE will be on the right side of the debris shield.
TRIMMING: This is feeding the trimmer carefully into
the material you wish to cut. Tilt the head slowly to
direct debris away from you. If cutting up to a barrier
such as fence, wall or tree, approach from an angle
where any debris ricocheting off the barrier will fly
away from you. Move the line head slowly until the
grass is cut right up the barrier, but do not
jam(overfeed )the line into the barrier If trimming up
to a wire mesh or chain linked fence be careful to
feed only up to wire. If you go to far the line will snap
off around the wire Trimming can be done to cut
through weed stems one at a time. Place the trimmer
line head near the bottom of the weed-never high up
which could cause the weed to chatter and catch the
line. Rather than cut the weed right through, just use
the very end of the line to wear through the system
slowly
WARNING DANGER Do not to use a steel blade for
edging or scalping
To Next Page
Loading...
