Original Bedienungsanleitung FUXTEC FX-RT226_rev02
46
SCALPING AND ENGING: Both of these are done with
the line head tilted at a steep angle Scalping is
removing top growth leaving the earth bear. Edging is
trimming the grass back where it has spread over a
sidewalk or drive way. During both edging and scalping,
hold the unit a steep angle and in a position where the
debris, and any dislodging dirt and stones will not come
back towards you even if it ricochets off the hard
surface. Although the picture shows how to edge and
scalp every operator must find for himself the angles
which suits his body size and cutting situation
WARNING DANGER Do not trim in any area where there
are strands of fencing wire. Wear protective safety
protecting, Do not cut where you cannot see what the
cutting device is cutting.
To Next Page
Loading...
Need help?
General
