G.A.S ENVIRO - Fan Temperature Adjustments; Setting Day;Night Fan Temps; Adjusting Temperature Values; Fan Temperature Bandwidth

10
USING YOUR
13 AMP ENVIRO CONTROLLER
SETTING THE FAN TEMPERATURE
From the Fan Settings Menu (as detailed on page 9),
press DOWN and scroll down to ‘Set temperature’.
With ‘Set temperature’ blinking, press ENTER to
access the temperature settings.
Use the UP and DOWN arrows to select your chosen
setting of Day, Night or Bandwidth.
With your chosen selection blinking press ENTER to
highlight the corresponding value.
Use the UP and DOWN arrows to change the value.
Press SAVE EXIT to save your information, and to go
back to the previous sub menu.
SETTING THE FAN HUMIDITY
From the Fan Settings Menu (as detailed on page 9),
press DOWN and scroll down to ‘Set humidity’.
With ‘Set humidity’ blinking, press ENTER to access
the humidity settings.
Use the UP and DOWN arrows to select your
chosen setting of Day, Night or Bandwidth.
With your chosen selection blinking press ENTER to
highlight the corresponding value.
Use the UP and DOWN arrows to change the
value.
Press SAVE EXIT to save your information, and to go
back to the previous sub menu.
FAN TEMPERATURE MENU
Select Fan Settings as detailed on page 9
Day 24.0°C
Press
to make your selection
Press to change value
to access Temperature Settings
Press
ENTER
to highlight the corresponding value
Press
ENTER
Pr
essing will save your entry and go back to the previous menu
SAVE
EXIT
Dump Override
Set fan Speed
Set temperature
Set humidity
Day 24.0°C
Night 20.0°C
Band width 3.0°C
FAN HUMIDITY MENU
Select Fan Settings as detailed on page 9
to highlight the corresponding value
Press
ENTER
Day 70%
Press
to make your selection
Press to change value
to access Humidity Settings
Press
ENTER
Pr
essing will save your entry and go back to the previous menu
SAVE
EXIT
Press
to scroll down to Set humidity
Dump Override
Set fan Speed
Set temperature
Set humidity
Day 60%
Night 50%
Band width 0.5%
FAN TEMPERATURE BAND WIDTH
The band width value is the difference in temperature
from when the fans start up and when they are going
at full speed.
The fans in the example to the right will start at 24°C
and ramp up to full speed in 3°C. Therefore the fans
will be at full speed at 27°C.
These humidity settings will set the
ventilation system to try to remove
humidity by extracting it.
TAKE CARE if using Exit 1 or 2 to control
either the humidifier or dehumidifier.
ALSO NOTE: particularly at night time,
temperatures can drop if the ventilation
system is removing humidity and
replacing it with cold air.
FAN SETTINGS MENU