G.A.S ENVIRO - EC Fan Signal Setup; Selecting Correct Signal Type; Saving EC Signal Settings; Fan Settings Menu Overview

SETTING THE EC SIGNAL
From the General Settings Menu (see page 6),
press DOWN and scroll down to ‘EC fan signal’.
With ‘EC fan signal’ blinking, press ENTER to
access the EC fan signal settings.
Use the UP and DOWN arrows to select the type of
EC Fan you are using.
Press SAVE EXIT to save your information, and to go
back to the previous sub menu.
Set Display
EC fan signal
Res. factory set
Set photosensor
EC SIGNAL MENU
Select General Settings as detailed on page 6
to access EC Signal Settings
Press
Set Time
Set Language
Pr
essing will save your entry and go back to the previous menu
Press
to scroll to your chosen setting
ENTER
SAVE
EXIT
Press
to scroll down to EC Fan Signal
Set EC Signal
0-10V Revolution
0-5V Hyper fan
PWM output
Make sure you get the correct
signal type for your fan.
FAN SETTINGS MENU
This menu allows you to change your fan settings such as:
• Temperature
• Bandwidth
• Humidity Settings
• Minimum Fan Speed
• Dump Override
TO ACCESS THE FAN SETTINGS MENU
From the Main Menu – Home Screen press ENTER
to access the sub menus.
‘Set fan Speed’ will be displayed and blinking.
Press ENTER to access the Fan Settings Menu
Press
to scroll down the sub menus
Dump Override
Fan settings
Set fan Speed
Set exit 1
Set exit 2
General settings
Room=23°C RH=60%
Set19°C 09:13
Start from the Main Menu – Home Screen
ACCESSING FAN SETTINGS
to access the first sub menu
Press
ENTER
to access the fan settings menu
Press
ENTER
Set temperature
Set humidity
9