USING YOUR
13 AMP ENVIRO CONTROLLER
GENERAL SETTINGS MENU
SETTING THE DISPLAY
From the General Settings Menu (see page 6),
press DOWN and scroll down to ‘Set Display’.
With ‘Set Display’ blinking, press ENTER to access
the display settings.
Use the UP and DOWN arrows to select your
chosen setting of Automatic, On or Off.
Press SAVE EXIT to save your information, and to go
back to the previous sub menu.
RESET TO FACTORY DEFAULTS
From the General Settings Menu (see page 6),
press DOWN and scroll down to ‘Res. factory set’.
With ‘Res. factory set’ blinking, press ENTER to
access the factory default settings.
Use the UP or DOWN arrows to select YES.
Press ENTER to confirm your choice and the
controller will begin to reset. The display will count up
to 100% and once the reset is complete, all 5 LEDs
will briefly illuminate, and the display with change to
the Main Menu – Home Screen. Your controller has
now been reset to factory defaults.
Set Display
EC fan signal
Res. factory set
Set photosensor
Select General Settings as detailed on page 6
to access Display Settings
Press
Set Time
Set Language
essing will save your entry and go back to the previous menu
Press
to scroll to your chosen setting
ENTER
SAVE
EXIT
Press
to scroll down to Set Display
LED back light
automatic
on
off
Set Display
EC fan signal
Res. factory set
Set photosensor
RESET TO FACTORY DEFAULT MENU
Select General Settings as detailed on page 6
to access Factory Default Settings
Press
Set Time
Set Language
All 5 LEDs will briefly illuminate, and the display will
change to the main menu –home screen
The display will count up to 100% and then display
Press
to scroll to select YES
ENTER
to confirm your choice
Press
ENTER
Press
to scroll down to Res. Factory Set
Reset controller
NO? YES?
Restore 100%
factory settings
Reset completed!
Please wait
8
To Next Page
Loading...