SETTING THE LANGUAGE
From the General Settings Menu (see page 6),
press DOWN and scroll down to ‘Set Language’.
With ‘Set Language’ blinking, press ENTER to
access the language settings.
Use the UP and DOWN arrows to select your
chosen Language.
Press SAVE EXIT to save your information, and to go
back to the previous sub menu.
SETTING THE PHOTOSENSOR
This menu shows the current Photosensor level
at the top. You can adjust the value for the
switch between day and night. The switch time
is the delay before the controller changes
mode from day to night, or night to day.
This is to stop the controller changing all the
environmental conditions if you open the door
of the grow room.
From the General Settings Menu (see page 6),
press DOWN and scroll down to ‘Set photosensor’.
With ‘Set photosensor’ blinking, press ENTER to
access the photosensor settings.
Press the UP or DOWN arrows to select ‘Switch at’ or
‘Switch Time’ and then press ENTER to select.
Press the UP or DOWN arrows to change the value
and then press SAVE EXIT to save your information,
and to go back to the previous sub menu.
7
Set Display
EC fan signal
Res. factory set
Set photosensor
Select General Settings as detailed on page 6
to access Language Settings
Press
Set Time
Set Language
Set language
English
Deutsch
Françiais
Italiano
Espańol
Nederlands
Press
to scroll to your chosen language
essing will save your entry and go back to the previous menu
Press
to scroll down to Set Language
ENTER
SAVE
EXIT
Set Display
EC fan signal
Res. factory set
Set photosensor
Select General Settings as detailed on page 6
Set Time
Set Language
Photosensor 35%
Switch at: 70%
Switch time 1s
Switch at: 70%
Press
to make your selection
Press to change value
to access Photosensor Settings
Press
ENTER
essing will save your entry and go back to the previous menu
SAVE
EXIT
Press
to scroll down to Set Photosensor
To Next Page
Loading...