-5-
1. Safety and EMC instructions
Please read carefully the following user manual and the
safety instructions before installing the unit or using the
unit!
1.1 Installation
★ Condensation may occur if the UPS is moved directly from a
cold to a warm environment. The UPS must be absolutely dry
before being installed. Please allow an acclimatization time of at
least two hours.
★ Do not install the UPS near water or in damp environment.
★ Do not install the UPS where it would be exposed to direct
sunlight or near heat.
★ Do not block ventilation openings in the UPS’s housing.
★ Place cables in such a way that no one can step on or trip over
them.
★ Socket-outlets and socket of batteries are earthed by the input
power cord, please insert the power cord into mains socket
before using of UPS.
★ Connect the UPS only to an earthed shockproof socket outlet.
★ The building wiring socket outlet (shockproof socket outlet)
must be easily accessible to close to the UPS.
★ This is operator installable .
★ Assure to connect with the earth reliably.
★ With the installation of the equipment,the sum of the leakage
current of the UPS and the connected load does not exceed
3.5mA.
To Next Page
Loading...
