EasyManua.ls Logo

G2 AR-22.1 - Page 23

G2 AR-22.1
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
2019/9/18V1.1+V1.0
The image above show the position of the belt and the way to wear. The sensor section A is in the groove in two sides. The sensor
section should be wet during the usage, otherwise the signal to the receiver will not be exact enough.
The belt should be worn below the pectorals, and you should adjust the belt to make the breath is smooth. If the sensor section touchs
the skin directly, the effect will be best, but wet cloth can also get the effect.
If you want to dampen the sensor section, you can hold the middle of the belt to drive out the belt to dampen the sensor section.
When setting heart rate exercise, user needs to set the start speed of the treadmill. If system
detects no chest belt pulse monitor, the max speed is 4.5mph(7.2Km). If system detects chest
belt pulse monitor, the maximum speed is 15.5mph(25Km).
Breast band heart rate belt (wireless belt) is the accessory.