COOL mode
DRY mode
FAN mode
HEAT mode (only applied to heat pump type)
In this mode, press temperature adjustment button to set temperature; press fan
speed button to change airflow speed of the indoor unit.
Press SWING button to set the airflow angle or adjust the vane swinging up and
down.
In this mode, only the indoor unit runs like the fan. Press fan speed button to
change the airflow speed and press swing button to set the airflow angle.
COOL DRY FAN
COOL DRY FAN HEAT
COOL ONLY TYPE:
HEAT PUMP TYPE:
In this mode, the air conditioner automatically decides the setting temperature
and this setting temperature will not appear on display. Neither the setting
temperature nor the fan speed could be adjustable. You can press SWING button
to set the airflow angle.
Press mode selection button on the remote controller to cycle the mode in the
following order:
In this mode, press temperature adjustment button to set temperature; press fan
speed button to change the airflow speed of the indoor unit.
Press swing button to set the airflow angle or adjust the vane swinging up and down.
¡±
Selected mode
Heating (For cooling only type, dehumidifying mode is selected)
Fan
Cooling
Room
Temperature (RT)
RT 20
RT 24
20 RT 24
OPERATION OF AIR CONDITIONER
7
B. After one hour of operation the set temperature will decrease by 2 . One hour later,
the set temperature will decrease by 2 once more. The unit will then continue
operating at 4 below the set temperature.
B. After one hour of operation the set temperature will increase by 1 . One hour later,
the set temperature will increase by 1 once more. The unit will then continue
operating at 2 above the set temperature.
A. The indoor fan runs at low speed.
Sleep mode in heating running.
SLEEP mode
A. The indoor fan runs at low speed.
Sleep mode in cooling and drying running.
To Next Page
Loading...
