OPERATION INSTRUCTION
15
In standby mode, press MICRO button once, press number button ‘3,1,2’ to enter the time, and
press POWER LEVEL button once, press number button’8’ to enter the power level. Do not press
START button.
Next press MICRO button once, press number button ‘4, 5, 6’ to enter the time and press POWER
LEVEL button once, press number button’5’ to enter the power level.
Press START to start.
1
2
3
1
2
Multi Stage Cooking
Your oven can be programmed for up to 2 microwave cooking sequences.
For example, you need to set the rst 3 minutes and 12 seconds for 80% power level and the second 4
minutes and 56 seconds for 50% power level. The operation is as follows:
Button Closed Protection
In any state, if any button on the control panel is closed for 60 seconds, the program stops working
immediately, the display shows "FAIL" and the system will sound beep. If the button keeps closing, beep
will sound every one minute. Any button is invalid at this time. After troubleshooting, press the
STOP/CANCEL button to return standby mode.
Child Lock
To set: In standby mode, press and hold LOCK more than 3 seconds, then a beep will sound, "LOCK ON"
appears on the display for 3 seconds and lock indication will light. In the lock state, all buttons are
disabled.
To cancel: Press and hold LOCK for more than 3 seconds, then a beep will sound, "LOCK OFF" appears on
the display and lock indication comes o.
Notes
Sensor cook, sensor reheat, soften melt and weight defrost, speed defrost cannot
set in multi stage cooking program.
The child lock prevents unsupervised operation by children and this program only works in standby mode
To Next Page
Loading...
Need help?
General
