CLEAN AND CARE
17
Cleaning and replacing the lters
Cleaning the grease lters
Clean the lters at least once a month. Never use the fan or microwave without the lters in place.
1 Pull down slightly on the tab toward the front of the microwave to remove the lter. Repeat for the other lter.
2 Soak the lter in a sink or dish pan lled with hot water and detergent.
CAUTION
DO NOT use ammonia or other alkali. They will react with the lter material and
darken it.
3 Agitate and scrub the lter with a brush to remove embedded dirt.
4 Rinse thoroughly and shake dry.
5 Replace by tting the lter back into the opening.
Grease lters
BOTTOM
Replacing the charcoal lter
A charcoal lter is used for nonvented, recirculated installation. The lter should be changed every 6 to 12 months
depending on use.
1 Disconnect power to the microwave at the circuit breaker or by unplugging it.
2 Remove the louver mounting screws from the top center of the louver, then push down on the tabs at each end
of the louver to disengage it.
Louver mounting screws
Louver
3
Pull the louver away from the unit.
To Next Page
Loading...
Need help?
General
