To Next PageTo Next PageWhy doesn't my Galcon Dc-6S valve open in auto or manual mode?
If the valve on your Galcon Controller isn't opening in either automatic or manual mode, there could be a connection issue between the controller and the solenoid. Try disconnecting and reassembling the solenoid. Alternatively, the batteries might be dead. In this case, replace them.
What to do if Galcon Controller valve stays open in AUTO?
If the valve remains open on your Galcon Controller even when the lever is in the AUTO position, the solenoid may be open. To resolve this, connect the controller to the valve, insert batteries, and then manually close and open the valve using the controller.
How to fix a Galcon Controller valve that won't close after hearing a click?
If you hear a click but the valve on your Galcon Controller doesn't close, first ensure that the valve lever is in the AUTO position. If it is, the issue might be dirt or scale in the valve mechanism. Try cleaning or replacing the valve to resolve this.
How to fix a Galcon Controller with no display?
If your Galcon Controller has no display, the batteries might not be working. Replace the batteries to see if this resolves the issue.
General| Brand | Galcon |
|---|---|
| Model | Dc-6S |
| Category | Controller |
| Language | English |
Guides through the process of installing batteries into the controller.
Covers mounting the controller on the solenoid or wall.
Details the process of connecting solenoid wires from the controller.
Instructions for setting the current time and day of the week for accurate operation.
Specifies the length of time the irrigation will run for each valve.
Determines which days of the week the controller will operate a specific valve.
Configures the specific times the irrigation cycles will begin.
Explains how to manually operate selected valves for a set duration.
Indicates critical low battery, disabling most functions and requiring reprogramming.
