To Next PageTo Next PageWhy doesn't the Galcon 6100 Controller valve open in automatic or computerized manual mode?
If the valve isn't opening, it could be due to a faulty connection between the controller and the solenoid. Try disconnecting and reconnecting the solenoid to the controller. Also, check the batteries and replace them if they are defective. Ensure that the operating lever is in the AUTO position.
What to do if Galcon 6100 Controller valve doesn't close after hearing a click?
If you hear a click but the valve doesn't close, first ensure the operating lever is in the AUTO position. If it still doesn't close, the valve mechanism might be dirty. Try cleaning the valve, and if that doesn't work, consider replacing it.
How to fix no display on Galcon 6100 Controller?
If there is no display, the batteries may be faulty. Replace the batteries.
Why is the Galcon Controller valve open when the lever is in AUTO?
If the valve remains open even when the lever is in the AUTO position, the solenoid might be electrically open. Connect the controller, install batteries, and try opening and closing the valve manually through the controller.
General| Type | Irrigation Controller |
|---|---|
| Power Source | 24 VAC |
| Input Voltage | 24 VAC |
| Number of Zones/Stations | 6 |
| Weight | 1 kg |
Instructions for inserting batteries into the controller and securing the battery compartment cover.
Steps for connecting the controller base to the solenoid and the controller unit.
Procedure for mounting the controller to a wall using a bracket and screws.
Guide for connecting controller wires to a 2-wire solenoid, including master valve and sensor connections.
Instructions for connecting controller wires to a 3-wire solenoid using waterproof connectors.
Explanation of the functions of the four buttons used for programming the irrigation controller.
Steps to set current time, day, and switch between AM/PM and 24-hour formats.
Procedure for selecting individual valves for programming irrigation schedules.
How to set the duration for irrigation, in hours and minutes.
Instructions for choosing specific days of the week for irrigation cycles.
Guide to programming up to four start times per day for selected valves.
A practical example demonstrating how to set up a weekly irrigation schedule.
How to program the controller for a single irrigation event.
Setting up irrigation cycles to run at fixed intervals.
Defining specific opening times and days for periodic or one-time irrigation.
A practical example of setting up a periodic irrigation program with specific frequency.
How to manually turn valves on and off for a set irrigation duration.
Operating all programmed valves sequentially, one after another.
Temporarily cancelling irrigation due to rain or other reasons without losing the schedule.
Adjusting irrigation duration for all taps simultaneously using percentage changes.
Explanation of the 'Waiting Mode' for valves when others are active or scheduled.
Understanding the blinking battery icon and how to replace batteries.
Interpreting the steady battery icon and the consequences of not replacing batteries.
Troubleshooting error 'No Prog' indicating unprogrammed irrigation duration.
How the controller interacts with connected sensors, like rain sensors, to control irrigation.
Key features specific to the 'S' series controllers, such as irrigation duration and frequency.
Setting irrigation duration within specific 'irrigation windows' for periodic programs.
Programming an irrigation window to start after a specific initial start time and how to cancel it.
Associating sensors with individual valves and turning the sensor function on or off.
Advice on battery removal, filter installation, cleaning, and recommended water pressure.
Table listing common problems, their causes, and recommended solutions.
Details of the 36-month limited warranty, exclusions, and customer remedies.
