Galcon 6100 Series User Manual

12
4.3 Valve Selection
This section does not apply to the DC-1 and DC1S models
An independent irrigation schedule program must be set for each valve
individually. First select the main valve, and then proceed with the irrigation
program as specified.
1. Press Enter
until appears.
2. Press Set
. A blinking arrow will appear
at the bottom of the display.
3. Place the arrow in front of the valve you
want to program using
and .
4. Press Enter
to proceed to the next
step.
DC4
valve
manual
now
duration
days
starts
4.4 Setting the Irrigation Duration
This setting determines how long the irrigation lasts.
1. Press “Enter”
until “Duration” appears.
2. Press “Set”
. The hour digit blinks. Set the desired number of hours by
pressing “Plus”
or “Minus” buttons. Press “Set” again - the
minute digits blink. Set the desired number of minutes by pressing “Plus”
or “Minus” buttons.
3. Press “Enter”
to proceed to the next step.

Galcon 6100 Series Specifications

General

Brand	Galcon
Model	6100 Series
Category	Controller
Language	English