11
4.1 Setting the Current Time and Day of the Week
The default time format is the AM/PM.
There is also the 24-hour time format.
To switch between the two formats:
1. Press “Enter”
several times until the
“Clock”
appears.
2. Press “Set”
. The hour digits blink.
3. Press “Plus”
and “Minus” buttons
simultaneously. The clock reading
switches from AM/PM to a 24-hour time
display or vice versa. You can switch the
time display format at any step in the programming process.
To enable the irrigation controller to operate the irrigation system at the
correct times, the current time and day of the week must first be set.
1. Press “Enter”
several times until the
“Clock”
appears.
2. Press “Set” . The hour digits will blink. Set the
current hour using “Plus” or “Minus” (note the
AM and PM terms).
Another click on the arrow
will cause the
minute digit to flash. Set the desired duration of
minutes using plus and minus
.
3. Press “Set”
. A blinking arrow appears at the top of the display. Place the
arrow in front of the current day of the week using the “Plus” or “Minus” buttons.
If the most recent data item stops blinking before you finish programming it, press
“Set”
to continue the programming process.
4.2 Switching Between AM/PM and 24 Hour Time Format
To Next Page
Loading...
Need help?
General
