READ ALL INSTRUCTIONS BEFORE INSTALLATION
has been designed to eliminate the need for an ignitio
n key to unlock, start and stop the vehicle,
makes use of a sophisticated electronic technology called Passive
RFID (Radio Frequency Identification). This technology allows all the same functions
completely hands free. Example: just walk up to the vehicle with the RFID key FOB in your pocket or purse and the
doors will unlock automatically. After sitting in the vehicle the driver can press the “
and the accessories will turn ON, OR Press and hold the “
Ignition will turn ON or will
. Put it in gear and drive away. To turn the vehicle off simple
and the engine will stop. After opening the door and walking away
from the vehicle, the doors will automatically lock and the accessories will turn OFF.
her security functions are standard with
Installation Requirements for
Automatic transmission only. (
ot for use with a manual transmission.)
If the vehicle is equipped with a locking steering column, the steering column lock m
Mechanically locking steering columns
be disabled by removing the steering
lock assembly and removing the column locking pin.
method can also be used. Insert a cutoff key blank in the ignition and
turn to the ON position. This
method requires that all electrical connections to the ignition key be disabled.
gasoline or diesel. Fuel injection is preferred
. Carbureted engines typically are not
compatible with Remote Start operation.
vehicle is equipped with a factory security key system, a security by
pass module will be activated when
These vehicle specific bypass modules
be supplied by the installer, or can be purchased
We do not recommend using
ules as they are not compatible with
Vehicles must have a properly functioning Park/neutral safety switch.
Must have a properly functioning emergency brake
Power door locks are required for maximum security
3RS must be connected to the parking lights.
To ease and reduce installation time, we suggest you consider the following points before starting:
Check all vehicle manufacturer
cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES,
ENGINE / BODY COMPUTER AND BATTERY).
Use extreme care and do not probe any wires of the SRS
Additional vehicle specific wiring diagrams and other helpful installation informa
tion can be found on our web site
www.gallotech.com/support.php
Determine the most suitable locations for all components to be placed. These components include: The control
button, siren or possible extra relays.
can be installed with or without the ignition switch. If the ignition switch is left functional then the
vehicle can be started with either the key or the “
to test and locate all connections.
Test Lights can damage a vehicle’s computer systems.
Record all color codes of vehicle wi
ring to be used for reference. This will save time by not having to re
same wires over again. Mark all vehicle wires with masking tape.
After locating and marking the appropriate wires
DISCONNECT the (+) POS terminal at the battery.
locking system the vehicle has before connecting any wires. Incorrect connection can
and/or vehicle locking system. There are several types of door lock systems in
): Many Imports; Late model Ford & General Motors
Negative trigger door lock systems send a Negative (Ground) pulse to existing factory relays to lock and
unlock the vehicle doors.
gger (+): Many General Motors; Chrysler / Dodge / Plymouth
To Next Page
Loading...