Gallo Tech GTS-3RS - Function Options

© Copyright
Gallo Technologies
. All Right Reserved
-
7
-
0
615
1
5
V54RS
GTS
-
3RS
has numerous user
programmable
features that can be enabled or modified according to user’s
preferences. This section explains each of the u
ser configurable functions. See
Sec.
1.
6
“
Key FOB &
Programming Function Set
-
Up Options”
for details on how to modify
programmable
features.
Valet Mode
: In DISARM mode, Pressing
the
valet switch for over 5 seconds will activate valet mode. Siren will ch
irp
2 times and the green
“Start Stop Engine” button
LED will stay ON
(not flashing)
.
To deactivate valet mode (normal status), press the valet switch for over 5 seconds. The siren will chirp one time
and the green
“Start Stop Engine” button
LED will flash
slowly.
In Valet mode all alarm function
and auto door locking
will be disabled. The key FOB buttons can lock and unlock
doors
, but not the trunk
or auxiliary output
. If the key FOB is in range, the vehicle can be started with the
“
Start Stop
Engine
”
but
ton
.
See Table 1
“Function Option Chart”
(page
-
9)
1
.
Remote Start Enable/Disable
:
Remote Start Enabled
(default):
Engine can be started using Remote Start function.
Remote Start Disabled
(optional)
:
Engine can not be started using Remote Start function.
2. Remote Start Run Time:
Run Time 10 minutes (Default)
.
When the engine is started using remote start, the engine will automatically turn
OFF after 10 minutes.
Run Time 15 minutes (optional).
When the engine is started using remote start, the engine will
automatically turn
OFF after 15 minutes.
3. Gasoline or Diesel Engine:
Gasoline Engine (default):
When the engine is started with Remote Start, there will be
a
0 sec delay after the Ign1
turns ON
before the started is engaged
.
Diesel Engine (optional):
W
hen the engine is started with Remote Start, there will be
a 15
sec delay after the Ign1
turns ON
, before the starter is engaged
.
4
.
Ignition 2 output Enable/Disable during Engine start
:
Disabled (default):
IGN2 output is OFF during the engine start seque
nce and ON after the engine is started.
(Duplicates the action of ACC).
Enabled:
IGN2 output is ON during the engine start sequence and stays ON after the engine is started. (Duplicates
the action of IGN1).
5
.
S
ilent
A
rm/Disarm
:
ON
(default)
:
Siren does
not chirp when locking / unlocking the doors.
OFF
:
Siren chirps when locking / unlocking the doors.
6
.
Foot
-
Brake
Door
lock/unlock:
ON (
default)
:
15 seconds after starting the engine the doors will automatically lock when the foot brake is pressed.
Doors
will automatically unlock when the engine is turned OFF.
OFF
:
After starting the engine the doors will not automatically lock.
7
.
Auto
Rea
rm:
OFF
(default)
:
The system will not automatically rearm and relock itself after the system
has been
disarmed
by
pressing
the trunk release
or
auxiliary output
button. The system can be rearmed by pressing the
(lock button) 1
time.
ON
:
The system will automatically rearm and relock itself
15 seconds
after the system is
disarmed
by
pr
essing the
trunk release or auxiliary output
button
8
.
Auxiliary output
Time:
2
Sec (default)
Auxiliary output pulse length set to 2 sec.
U
se this setting if unlocking passenger shaved doors
15
Sec (optional)
Auxiliary output pulse length set to 15 sec. U
se this setting for a window close operation.
1.
5
FUNCTION OPTIONS