Installer must determine if voltage or Tach RPM detection is to be used. Both methods will
however the Tach signal method requires additional setup and the availability of an
appropriate Tach signal from the vehicle.
If the Tach signal method is used, Program Option #13 must be
light blue) is connected.
Voltage/ Tach signal detection Options
The system will detect the engine is running by either a voltage rise or the
See Table 1 option 13 to set the voltage/tach detection option.
: By way of connector C3 Pin 2, the system will look for a 1 volt voltage rise after
Remote start has been activated. If the voltage does not increase by 1 volt, the system will try to start one
more time. If the voltage does rise by 1 volt or highe
r, the parking lights will flash
running engine. The connector C3 Pin 2
(light blue) wire should not be connected to a Tach signal if
voltage detection is used.
Tach signal detection option
wire must be connected to one of the appropriate tach signal
) terminal of a fuel injector
) terminal of an ignition coil
Do not connect the C3 pin 2
lue) Tach input wire if voltage detection is used.
Tach signal (RPM) learning
: The Tach signal detection circuit will detect an over
condition based on the normal idle RPM. If the engine starts in the Remote Start mode, and the
s than ½ or greater than 2x the normal idle RPM, the Remote Start sequence will stop
and the engine will turn OFF.
After connecting the Tach wire to the appropriate tach signal (above),
must be learned into memory
Start the engine and let it idle at its normal idle RPM.
Press the Valet button 7 times and hold it on the 7
press for approx 5 sec. When the
parking lights flash 3 times, release the Valet button.
n will start to flash rapidly.
When the engine is running at its normal idle speed, press the FOB “
. The parking lights will flash 3 times indicating the idle RPM has been learned.
following conditions must be met before Remote Starting:
System in the armed mode,
Key FOB out of range (more than 1
Automatic trans. gear selector in Park/neutral position.
Remote Start cycle will begin.
If the engine does not start on the first attempt (det
ected by voltage rise or Tach signal) the
system will automatically try to restart one more time. If engine does not start on the second
attempt the system will shut down. Remote Start can be reactivated again by pressing
When the engine does start the parking lights will flash every 2 sec, After 10 / 15 minutes
(selectable) the engine will turn OFF and the system will remain in the armed mode. Parking lights
button 1 time, will turn the engine OFF or stop the Remote Start operation.
After Remote Start has been activated and the engine is running, the driver may approach the vehicle with the
key FOB. The doors will unlock and the driver can enter
the vehicle. The engine will keep running. The parking
lights will continue to flash indicating the turn OFF time
If the driver wants to drive
the vehicle the handbrake
The parking lights will stop flashing
the vehicle if the parking lights are flashing as the engine will turn OFF once the 10/15 minute timer runs
: Any one of the following steps will turn the engine OFF after it has been Remote Started:
1 time, open a door (alarm will also sound) or release the hand brake.
To Next Page
Loading...