System must be in Disarm mode (
Press valet switch 5 times, hold
for over 5 seconds, parking lights will flash 2 times.
According to the “Function Option Chart” below, you can set up the required function by pressing the Va
Switch the number of times indicated in Table 1
Immediately after pressing the valet switch the number of time indicated
button on the key FOB. If
the parking lights flash 3 times, the default setting
for that function has been set. If the parking lights flash 1 time,
the alternate setting has been set.
Note: After entering the “Function Programming” mode, the
button must be pressed on the key FOB within 5
not, the system will exit the “Function Programming” mode and the parking lights will flash 4 times.
Repeat steps 1 thru 4 for each additional programming function.
Table 1: FUNCTION OPTION CHART
To Next Page
Loading...