Chapter 4 -- Installation--Firmware Update
4 - 13
Figure 4-9
Firmware Update Tab
Depending upon which code you wish to update, click on Update Instrument Firmware or Update
Communications Firmware. You will then be prompted for a file. Navigate to the file’s location (on the
Gamry software CD or on your computer’s hard drive) and then press Open. The update procedure will
begin. A status bar shows the progress of the update. The USB indicator on the Reference 3000 should also
turn red during the procedure. Once the update is successful, press OK and your Reference 3000 will be ready
for use.
Once again, appropriate update files can be obtained from the Gamry Instruments website at www.gamry.com.
Should you encounter a problem updating the firmware in your Reference 3000, please contact Gamry
Instruments for assistance.
Interrupting a firmware update can cause a catastrophic failure of your system. Do not turn off the Reference
3000, do not unplug the USB cable, and do not stop the host computer operation when the USB LED is a
steady red color.
Caution
Do not interrupt a firmware update that is in progress. An incomplete update can render
a Reference 3000 inoperable until it is returned to Gamry for reprogramming.
To Next Page
Loading...
