Chapter 4 -- Installation--Authorization Codes and Label
4 - 10
You can delete an Absent instrument by selecting Delete when an instrument is selected. Deleting an
instrument simplifies the Instrument Manager dialog box. It has little effect otherwise; the deleted instrument
can be reconnected later.
When you setup an experiment, you will need to select the potentiostat used to run the test. The instruments
will appear in the order shown in the Instrument Manager, with the device in the top row displayed first. The
Up and Down buttons allow you to move a device in the dialog box and change the order in which devices are
displayed.
Authorization Codes and Label
If you purchase additional Gamry application software or you need to make a correction to your authorization
codes, you can do so using the Windows Device Manager or the Framework Instrument Manager.
The dialog box used to enter authorization codes also allows you to change the Label for your device. The
Gamry Framework Application Software must be closed before you can use the Device Manager to make
changes. Next, you must select the appropriate device, as discussed in the Device Manager and Instrument
Manager discussions above. In the Windows Device Manager, once you have selected the appropriate device,
right click and select Properties. Next, select Device Settings and you will see a screen that looks like Figure
4-7:
To Next Page
Loading...
